Sublimation Business Cards & Holders
Plastic Business Card
Item SBC-P * White Business Card: Rectangle Plyable Translusent Plastic, 2-sided, with rounded corners. These cards make excellent advertising items. Dimensions: 2″ x 3.5″ x .02″
Qty 100/case – Broken cases billed as each.
$0.50 ea less than case
$0.45 ea per case qty
$0.40 ea per 4 case qty
Chromaluxe Aluminum Business Card
Item UNI4329 * ChromaLuxe® Business Card: Gloss White, Rectangle Aluminum, 2-sided Gloss White, 2″ x 3.5″ x .045″ with 1/8″ rounded corners. These cards make excellent advertising items. Dimensions: 2″ x 3.5″ x .045″
Qty 50/case – Broken cases billed as each.
$2.81 ea less than case
$2.37 ea per case qty
$2.20 ea per 4+ case qty
Executive Desk Name Plate
Item UNI5752 * Executive Desk Name Plate: Mahogany Wooden Desk Set with Business Card Slot. 2” tall, 2.5” wide, includes a 1.68” x 9.375” x 0.030” aluminum insert, two holes for pens/pencils, and a slot for business cards. Card slot holds up to fifty 2” x 3.5” business cards. Size 2” x 2.5” x 9.5”
Qty 10/case – Broken cases billed as each.
$27.08 ea less than case
$22.84 ea per case qty
$21.15 ea per 4+ case qty
Transfer Instructions UniSub Metals:
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* If the product has a protective plastic covering remove it.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Cover imprintable with parchment or paper
* Press at 385 degrees F for 40-50 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
– You can also try pressing the metal from the back side
These transfer instruction guidelines were created using a Swing-Away GeoKnight Press, size 20″ x 24″/508 x 609.6 mm with pressure of 60 PSI. They represent the best, most general instructions we can provide. Please remember that heat presses may vary. Check with your press manufacturer for any special concerns. This information may change as we make continual improvements and refine our processes. These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.
Transfer Instructions for SBC Business Cards:
* Prepare artwork and size transfer according to the size and shape of the product.
* Image must be produced in reverse or “mirror image”
* Place a sheet of plain white paper on the press.
* Remove the protective plastic covering from the product.
* Using heat resistant tape, secure the image with the printed side of transfer facing the product
* Lay the imprintable face up on the heat press so that you are pressing onto the transfer.
* Press at 385 degrees F for 40-50 seconds using Medium pressure
* When pressing is finished carefully remove the transfer paper and allow to cool on a clean surface
Note: If you are using an item that can be printed on both sides allow the metal to cool to room temperature before pressing the 2nd side.
Note: These instructions are guide lines only and are based on the inks, paper, and products we supply. Your inks, papers, etc. may require adjustments in your time/temp settings.